G3 Topsheet-Mounted Tail Connectors ACCESSORIES G3
G3 Topsheet-Mounted Tail Connectors ACCESSORIES G3
G3 Topsheet-Mounted Tail Connectors ACCESSORIES G3

G3 Topsheet-Mounted Tail Connectors

G3-9159

Regular price$10.00
/

6 in stock!

Secure and Trusted Checkout With:

Visa MasterCard American Express Discover Apple Pay Shopify

Utah Ski Gear offers a
100% SATISFACTION GUARANTEE

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Looking for ultra-fast transitions? Replace the tail connector on your G3 climbing skins with this lightweight and simple accessory to be lighter, faster, and more packable! These connectors mount permanently to your ski/board topsheet with a bomber adhesive.

  • Sold as a pair
    • Removes bulk from packed skins
    • Super fast and easy transitions
    • Compatible with any G3 climbing skins with holes in the tail strap
    • Weighs just 2g each (saving 13g vs traditional tail clips)
    • Fits skis and boards of any shape
    • Mounts permanently
    • Made in Canada

Instructions:

1. Cleaning the Topsheet:

a) Working at room temperature, wipe the tail end of the ski or board top sheet with isopropyl alcohol to remove any contaminants.

2. Tail Connector Placement:

a) Put your skin on your ski or board to line up where the tail strap holes fall

3. Tail Connector Installation:

a) PLEASE NOTE: Once the tail connector is placed on the ski or board topsheet, the tape will immediately bond.

b) Before removing the red tape release liner, align the tail connector with the rounded edge pointed toward the tip of the ski or board

c) Align the tail connector with your skin strap holes (see photo below) and apply tension to the strap

d) Mark where the straight edge of the tail connector sits on your topsheet and remove the tail strap

e) Remove the tape release liner from the back of the tail connector

f) Place the tail connector on the ski or board top sheet where you previously marked

g) Apply pressure for 30 seconds on the tail connector with the tape against the topsheet After application, the bond strength will increase as the adhesive wets out on the surface. At room temperature, approximately 50% of ultimate bond strength will be achieved after 20 minutes, 90% after 24 hours and 100% after 72 hours.

About Utah Ski Gear:

Utah Ski Gear was established in 2011 and we believe that skiing is for everyone. Helping our customers find the right equipment to get them and their families skiing is our passion. We understand price can be the biggest deterrent and because of this we offer new and used skis on a budget. For the more experienced skier looking for advanced gear, we offer hard-to-find accessories like specialized tuning equipment and high-performance skis. Customers preferring maximum comfort while skiing can find electric boot heaters, such as Hotronic FootWarmers.

Listing Notes:

Photos are stock photos and are not the property of Utah Ski Gear. 

Customer Reviews

Be the first to write a review
0%
(0)
0%
(0)
0%
(0)
0%
(0)
0%
(0)

Recently viewed